PhysicsClassical Physics

Knowledge guide

Kirchhoff's Circuit Laws: Junction Balance, Loop Signs and Negative Currents

Turn a circuit into independent junction and loop equations, assign voltage-change signs consistently, and interpret a negative current without changing the original reference arrows.

Two conservation statements

For steady currents in an ordinary lumped DC circuit, a junction does not continuously accumulate charge. Kirchhoff's current law therefore gives:

∑Iin=∑Iout.\sum I_{\mathrm{in}}=\sum I_{\mathrm{out}}.

Kirchhoff's voltage law gives zero net potential change around a closed path:

∑ΔV=0.\sum\Delta V=0.

The first tracks charge. The second tracks energy per unit charge. Neither requires every branch to carry the same current.

Assign reference directions before writing equations

An unknown current needs an arrow so that algebraic signs have a defined meaning. The arrow is a choice of reference, not a prediction that must be correct. Choose a traversal direction separately for each loop and keep it unchanged while writing that equation.

Element crossedTraversalPotential change
Resistor R with reference current IAlong the current arrow−IR
Resistor R with reference current IAgainst the current arrow+IR
Ideal source with emf εNegative terminal to positive terminal+ε
Ideal source with emf εPositive terminal to negative terminal−ε

For a source with internal resistance, include the resistor's IR term separately. The emf and the terminal voltage under load are not generally equal.

A new junction example

Suppose a 5.0 A current enters a node, 8.0 A leaves along one branch, and an unknown I is initially drawn leaving along another branch:

5.0=8.0+I,I=−3.0 A.5.0=8.0+I,\qquad I=-3.0\,\mathrm{A}.

The unknown branch actually carries 3.0 A into the node. Then 5.0 + 3.0 = 8.0 A. Retaining the negative algebraic value in the original equation makes that reversal explicit.

A new loop example

A 10 V ideal source drives two series resistors of 2 Ω and 3 Ω. Traversing from negative to positive through the source and then along the current through both resistors gives:

10−2I−3I=0,I=2 A.10-2I-3I=0,\qquad I=2\,\mathrm{A}.

Reversing the entire traversal gives −10 + 2I + 3I = 0, with the same solution. Reversing only one term without changing how its element is crossed is an error. These examples use different circuits and numbers from the related Question.

Use independent equations and verify them

Label nodes, branch currents, source polarities and resistances before choosing loops. A resistor shared by two loops has one physical branch current; if using mesh currents instead, that branch current is their signed combination. Do not mix those two definitions.

Write enough independent equations for the unknowns. A second junction equation may repeat the first, and a loop equation may be the sum of previously written loops. Solve the resulting system, then substitute the signed currents into every original equation.

A zero junction residual confirms current balance. A zero loop residual confirms the algebraic voltage balance for that path. These checks detect sign or arithmetic errors, but cannot validate a circuit diagram whose connections were entered incorrectly.

Scope of the simple loop rule

The zero-sum scalar-potential form used here assumes the ordinary DC circuit model. When a changing magnetic flux links a loop, induced emf must be included consistently. Within the stated model, keep source polarity and resistor traversal separate from the sign of the solved current.

Related question

Apply this knowledge

Use the concept guide to understand the reasoning, then return to the complete question and worked answer.

Kirchhoff's Circuit Laws: Three Branch Currents with 18 V and 45 V Sources

Sources

These references support the core concepts and interpretation boundaries explained above.