PhysicsClassical Physics

Static Friction Formula: Maximum Push on a 120 kg Crate

Find the maximum static friction for a 120 kg crate, then use kinetic friction to calculate its acceleration once it slips.

Question

A 120 kg120\,\mathrm{kg} wooden crate sits on a wooden floor. For these surfaces, μs=0.500\mu_s=0.500 and the sliding-friction coefficient is μk=0.300\mu_k=0.300.

(a) Find the largest horizontal push the crate can withstand while remaining at rest.

(b) If that same push is maintained after slipping begins, determine the crate's acceleration.

Answer

The maximum horizontal push before slipping is 588 N588\,\mathrm N. Maintaining that push after slipping begins gives an acceleration of 1.96 m/s21.96\,\mathrm{m/s^2} in the push direction.

(a) Maximum push while the crate stays at rest

The floor is horizontal and the applied push has no vertical component. Using g=9.80 m/s2g=9.80\,\mathrm{m/s^2}:

N=mg=(120)(9.80)=1176 N.N=mg=(120)(9.80)=1176\,\mathrm N.

Static friction adjusts to balance the push while equilibrium remains possible:

0≤fs≤μsN.0\le f_s\le\mu_sN.

The maximum occurs at the threshold of slipping:

Fmax⁡=fs,max⁡=μsN=(0.500)(1176)=588 N.F_{\max}=f_{s,\max}=\mu_sN=(0.500)(1176)=\boxed{588\,\mathrm N}.

This is the ideal model's limiting value. A push below 588 N588\,\mathrm N is balanced by an equal friction force; static friction is not automatically 588 N588\,\mathrm N for every push.

(b) Acceleration after slipping

Once the crate slides, use μk=0.300\mu_k=0.300, not μs\mu_s:

fk=μkN=(0.300)(1176)=352.8 N.f_k=\mu_kN=(0.300)(1176)=352.8\,\mathrm N.

The original 588 N588\,\mathrm N push is maintained, so

Fnet=588−352.8=235.2 N,F_{\mathrm{net}}=588-352.8=235.2\,\mathrm N,

a=235.2120=1.96 m/s2.a=\frac{235.2}{120}=\boxed{1.96\,\mathrm{m/s^2}}.

As a check, at this threshold push a=(μs−μk)g=(0.500−0.300)(9.80)=1.96 m/s2a=(\mu_s-\mu_k)g=(0.500-0.300)(9.80)=1.96\,\mathrm{m/s^2}.

Direction check

Both static and kinetic friction act opposite the push in this scenario. The post-slip net force is positive in the push direction because kinetic friction is smaller than the maintained applied force.

Evidence boundary

This answers Chapter 6 Problem 48 using the coefficients explicitly supplied in that University Physics version: μs = 0.500 and μk = 0.300. It assumes a horizontal push, level floor, g = 9.80 m/s² and the ideal dry-friction model. The calculation is a theoretical threshold, not a measured breaking-away force.

Sources

Эти источники подтверждают изложенные выше концепции и методы.