PhysicsClassical Physics

Angela and Carlos Are Asked to Determine the Relationship Between Normal Force and Incline Angle

Derive the normal force for Angela and Carlos’s resting box, linearize their seven measurements, and explain the graph slope.

Question

Angela and Carlos are asked to determine the relationship between the normal force on a box of mass mm and the incline angle θ\theta while the box rests on the incline.

Dot on a right-rising dotted incline for Part A

A. Draw a free-body diagram at the dot. Label the forces, not their components; each force needs a distinct outward arrow whose length reflects its magnitude.

B. Begin with ∑Fy=may\sum F_y=ma_y and derive NN in terms of mm, θ\theta and constants, explaining each step.

Normal force (N)Incline angle (degrees)
9710
9515
8530
8035
7540
6350
4960

C. From the equation in B, what should be plotted to make a linearized graph? D. What does that graph's slope mean physically?

A. At the dot draw three arrows: weight mgmg vertically downward, normal force NN perpendicular away from the incline, and static friction fsf_s up the incline (the block would otherwise tend to slide down). Do not draw mgsin⁡θmg\sin\theta or mgcos⁡θmg\cos\theta as additional forces; they are components of the single weight vector. For any angle with 0<θ<90∘0<\theta<90^\circ, draw lengths in the ratios mg:N:fs=1:cos⁡θ:sin⁡θmg:N:f_s=1:\cos\theta:\sin\theta. Thus weight is longest; N>fsN>f_s below 45∘45^\circ, equal at 45∘45^\circ, and fs>Nf_s>N above 45∘45^\circ. The following illustrative diagram uses an angle near 24∘24^\circ; the ratio rule, not that particular drawing, applies to all seven angles.

Weight, normal force and uphill static friction from the dot

B. Choose positive yy perpendicular outward from the plane. Newton's second law says ∑Fy=may\sum F_y=ma_y. The box is at rest, so ay=0a_y=0. Static friction is parallel to the plane and has no yy component; gravity contributes −mgcos⁡θ-mg\cos\theta. Hence N−mgcos⁡θ=0N-mg\cos\theta=0, and therefore N=mgcos⁡θ\boxed{N=mg\cos\theta}. Along the plane, 0=∑Fx=fs−mgsin⁡θ0=\sum F_x=f_s-mg\sin\theta, which also gives the friction length used in A.

C. Plot measured normal force NN (vertical axis, newtons) against cos⁡θ\cos\theta (horizontal axis, dimensionless), not against angle in degrees. The seven horizontal coordinates, in table order, are approximately 0.98481, 0.96593, 0.86603, 0.81915, 0.76604, 0.64279 and 0.50000. The theoretical line is N=(mg)(cos⁡θ)N=(mg)(\cos\theta) through the origin.

D. The line's slope is mgmg, the box's weight in newtons. The seven rounded observations give a freely fitted slope of about 98.9 N and an intercept near −0.6 N; the small nonzero intercept does not change the theoretical meaning of the slope. If g=9.8 m/s2g=9.8\,\mathrm{m/s^2}, that slope corresponds to an inferred mass near 10.1 kg, but the original task asks for the slope's physical meaning, not a measured mass.

Evidence boundary

The workbook gives no numerical mass or angle for Part A, so the force-arrow lengths can show only the relative magnitudes mgmg, mgcos⁡θmg\cos\theta, and mgsin⁡θmg\sin\theta; the illustration uses one example angle. The seven force readings are experimental observations, not exact points on an error-free theoretical line. A numerical fitted slope depends on the fitting convention, although its physical meaning remains mgmg.

Sources

Các nguồn này hỗ trợ những khái niệm và phương pháp được giải thích ở trên.