Energy arrives one photon at a time
In the ordinary single-photon photoelectric effect, one photon transfers energy to one electron. Its energy is:
The work function φ is the minimum energy needed for an electron to escape a particular surface. Energy left after escape sets the maximum kinetic energy:
This is an upper limit. Other emitted electrons may have less energy because of their initial states or energy lost before escaping.
Check the threshold before reporting an energy
The threshold frequency and longest permitted wavelength obey:
For hf < φ, the ordinary single-photon process cannot eject an electron. A negative value from hf − φ signals that emission is energetically forbidden; it is not a physical negative kinetic energy. At the ideal threshold, the maximum emerging kinetic energy is zero.
Keep joules and electron volts separate
Use either h = 6.626 × 10⁻³⁴ J·s with φ converted to joules, or h ≈ 4.136 × 10⁻¹⁵ eV·s with φ in eV. For wavelength calculations, hc ≈ 1240 eV·nm is convenient.
One electron volt is 1.602 × 10⁻¹⁹ J. Convert energy by that factor, rather than treating eV as a voltage unit.
A fresh example with specified hypothetical data
Take a hypothetical surface with work function 2.00 eV and incident light frequency 8.00 × 10¹⁴ Hz. Then:
Its maximum electron kinetic energy is 3.31 − 2.00 = 1.31 eV. The threshold frequency is approximately 4.84 × 10¹⁴ Hz, so the given frequency is above threshold. This example deliberately supplies hypothetical data and does not reuse the sodium Question.
At 4.00 × 10¹⁴ Hz, the same hypothetical surface would not emit through the single-photon process because the photon energy would be only 1.65 eV.
Frequency and intensity play different roles
At fixed surface properties, increasing frequency increases each photon's energy and therefore increases Kₘₐₓ above threshold. Increasing intensity at fixed frequency supplies more photons per unit time, which can increase the emission rate under otherwise comparable conditions. It does not increase the energy per photon or the single-photon maximum kinetic energy.
Thus brighter below-threshold illumination does not overcome the work function in this model. Multiphoton processes at high intensities are outside this elementary calculation.
Connect the energy to a stopping voltage
A retarding potential can prevent even the fastest emitted electrons from reaching a collector. For stopping-voltage magnitude Vₛ:
A maximum energy of 1.31 eV corresponds to a stopping-voltage magnitude of 1.31 V. The numerical equality comes from the definition of an electron volt; voltage and energy remain different physical quantities. Work functions depend on surface conditions, so predictions stay tied to the work function specified in the problem.
Related question
Apply this knowledge
Use the concept guide to understand the reasoning, then return to the complete question and worked answer.
Photoelectric Effect: Maximum Electron Energy for Sodium under 450 nm LightSources
These references support the core concepts and interpretation boundaries explained above.