Momentum conservation starts with a system
The law of conservation of momentum concerns the total vector momentum of a chosen system. It does not require each object to keep its own momentum. During a collision, an object can gain momentum while another loses the same amount.
For a fixed set of constant-mass objects,
If the external impulse over the selected interval is negligible, the initial and final total momenta are equal. Zero net external force throughout the interval is a sufficient condition. A substantial external force can still have little impulse over a sufficiently short interval, but that approximation needs justification.
Make the boundary explicit
For a collision between two freely moving bodies, include both bodies. Their mutual forces are internal. A wall's force remains external if the wall is outside the system, so a single ball bouncing off a wall does not conserve its own momentum.
State the axis and frame before writing a scalar equation. In two dimensions, conserve each component separately; adding speed magnitudes ignores direction.
Count the unknowns before selecting equations
Two unknown final velocities cannot generally be determined by the single one-dimensional momentum equation. A sticking condition gives one common velocity. A perfectly elastic condition supplies kinetic energy conservation. A stated restitution coefficient can instead constrain relative velocities.
Energy conservation must be supported by the collision model. The law of conservation of momentum alone does not imply kinetic energy conservation.
A new example: unequal blocks on an air track
A block traveling at collides elastically with a stationary block. Neglect external impulse along the track. The collision solution gives the incoming block and the heavier block .
Momentum checks as
The individual momentum changes are and . Their sum is zero. The kinetic energy is both before and after. The final relative motion separates the blocks, rather than preserving their incoming approach.
A reusable verification sequence
First check the system and external impulse. Then use one signed axis for every velocity. Count unknowns and justify every extra equation. Finally, substitute unrounded final velocities back into momentum and, only for an elastic model, kinetic energy. A small mismatch after final rounding can be numerical; a mismatch in the unrounded calculation needs investigation.
Related question
Apply this knowledge
Use the concept guide to understand the reasoning, then return to the complete question and worked answer.
Law of Conservation of Momentum: Final Velocities of Two Hockey PucksSources
These references support the core concepts and interpretation boundaries explained above.